ESAB MultiPower 460 Pulse Instrukcje Operacyjne Pobierz pdf (Strona 14)

Figure4-1 Standard Mig Setup Procedure

D. STANDARD MIG (CV) WELDING

When the PROCESS switch is placed in the MIG position the MultiPower 460

Pulse is set for CV (constant voltage) welding. The power source will output

open circuit voltage (OCV) when the Mig Gun trigger is depressed. The

following procedure assumes the wire feed and voltage adjustments will be

made from the wire feeder front panel and wire and gas have been installed.

Step 1. Connect wire feeder to MultiPower 460 Pulse and set PANEL/RE-

MOTE switch to REMOTE position.

Step 2. Set the MIG STANDARD/PULSE switch to the MIG STANDARD po-

sition.

Step 3. Place the WELD PROCESS switch in the MIG (center) position.

Step 4. Press and release the PRESET button then turn the wire speed

control on the wire feeder to the desired speed shown on the top

digital display window of the MultiPower 460 Pulse.

Step 5. Turn the VOLTAGE knob of the wire feeder to the desired arc

voltage in the bottom digital display window of the MultiPower

460 Pulse.

Step 6. Set the shielding gas flow rate to 35 cfh by activating the gas purge

switch on the wire feeder or pulling the gun trigger and turning the

adjustment knob on the Flowmeter.

Step 7. Connect the work cable to the part top be welded and pull the gun

trigger to start welding. Trim the wire speed and volts as needed for

the desired arc characteristics and weld quality.

SECTION 3 OPERATION

NOTE

Place MIG STANDARD/MIG PULSE

switch in the MIG STANDARD position

when using the Tig, Stick or Arc Gouging

process modes.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Brak uwag

ESAB MultiPower 460 Pulse Instrukcje Operacyjne Strona 14