ESAB MultiPower 460 Pulse Instrukcje Operacyjne Pobierz pdf (Strona 12)

SECTION 2 INSTALLATION

IV. PULSE CONTROL PANEL INSTALLATION

The standard MultiPower 460 control panel are easily removed and replaced

with the MultiPower 460 Pulse version using the following procedure. Refer to

Figure 4-1.

Step 1. Disconnect ALL primary power from the MultiPower 460 by unplug-

ging the unit or removing the line fuses.

Step 2. Remove the four screws (one at each corner) holding the standard

MultiPower 460 control panel in place.

Step 3. Tilt the panel forward and disconnect the wiring harness plug connec-

tor and remove the control panel from the PC board compartment. Do

not discard this panel is can be used as a spare replacement panel if

problems arise.

Step 4 Connect the NEW MultiPower 460 Pulse control panel harness plug

to the power source harness.

Step 5. Carefully position the control panel over the PC board compartment

and secure with the mounting screws removed from the standard

control panel.

Panel Screws

Panel Harness Plug

Figure 4-1 MultiPower 460 Pulse Harness Connection

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Brak uwag

ESAB MultiPower 460 Pulse Instrukcje Operacyjne Strona 12