ESAB MultiPower 460 Pulse Instrukcja Obsługi Pobierz pdf (Strona 28)

OPERATION

SECTION 4

When the WELD PROCESS switch is

moved to the TIG or STICK position,

electrode becomes electrically

“HOT”. Do not allow the electrode to

contact ground potential until you are

ready to make a weld.

Arc Force is automatically enabled when the WELD PROCESS switch is set

to the STICK position. The level of Arc Force is automatically adjusted by the

current preset being used.

Step 1. Be sure to set the polarity to DCEP (Electrode Positive) by placing

the Electrode Holder cable in the Positive connection lug on the front

of the power source.

Step 2. Place the WELD PROCESS switch in the STICK position.

Step 3. Place the PANEL/REMOTE switch in the PANEL position.

Step 4. While holding the PRESET button, turn the VOLTAGE/CURRENT

knob to the desired weld current in the top digital display window.

Step 5. Strike the electrode on the workpiece and start welding. Trim the

welding current as needed for the desired weld pool control.

Step 2

Step 3

H. AIR CARBON ARC GOUGING (CAC-A)

1. CONSTANT CURRENT and CONSTANT VOLTAGE GOUGING

Step 1. Place the Output PANEL/REMOTE switch into PANEL position if

output current is regulated from the VOLTAGE/CURRENT knob on the

power source front panel, or in REMOTE position if output current is

regulated from the optional Hand Control.

Step 2. Place the Process Control switch in the STICK position.

Step 3. Press and hold the PRESET button and set the VOLTAGE/CURRENT

knob to gouging current.

Figure 4-3 Standard Stick Setup Procedure

Step 4

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Brak uwag

ESAB MultiPower 460 Pulse Instrukcja Obsługi Strona 28