ESAB MultiPower 460 Pulse Instrukcja Obsługi Pobierz pdf (Strona 17)

Figure 2-6. Remote Control Pendant

DESCRIPTION

SECTION 2

NOTE

If a Remote Control Pendant is used for

continuous current control, place the

PANEL/REMOTE switch in the PANEL

POSITION and set the Panel Current knob

to the maximum desired weld current. The

remote device will then control the current

between minimum and the maximum set-

ting preset (proportional current control).

Maximum Tig weld current is 525 amps.

NOTE

If the MP-460 PANEL/REMOTE switch

is left in the REMOTE position when Tig

welding while using a remote current

control device, the current range will

be full scale or 10 to 400 Amps.

Limiting the the Maximum weld current

on the MP-460 front panel is defeated.

NOTE

When using the MP-460 Pulse, the

STANDARD/PULSE switch must be in

the STANDARD position for proportional

current control using a TIG remote

current device.

E. OPTIONAL ACCESSORIES

1. REMOTE CONTROL PENDANT (PN - 0558002871)

This pendant (Figure 2-6) provides remote output control and a contactor

closure switch to close the contactor making the output terminals “hot”. The

PANEL/REMOTE switch on the MultiPower 460 Pulse control panel must be

placed in the REMOTE position when using this accessory. The pendant

has the capability to change weld processes as well as adapt to digital and

analog wire feeders.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Brak uwag

ESAB MultiPower 460 Pulse Instrukcja Obsługi Strona 17