ESAB MultiPower 460 Pulse Instrukcja Obsługi Pobierz pdf (Strona 19)

NOTE

Power sources with pulsing capability built into the power source (such as the MultiPower 460 Pulse)

can utilize any of the MMI panels for pulse operation and does NOT require the Digital Dual; Schedule

Pulse MMI panel.

Digital Dual Schedule MMI Panel

The Digital Dual Schedule MMI panel has all the capability of the Basic Dual Schedule panel with the addition of a digital

WFS and VOLT meter. The digital WFS meters adds digital presettability to the wire feed speed. The digital wire feed speed

can be preset to the IPM (inches per minute) setting desired and the control circuitry will maintain that wire feed speed

within +/- 2 ipm. A preset display of the arc voltage is NOT supported. During welding, the average WFS and VOLTS is

calculated and the display updated 3 times a second. The last reading is then held for 10 seconds after welding has com-

pleted for weld parameter verication and recording.

SECTION 1 DESCRIPTION

NOTE

Either the 4-in-1 Option Module or the Pulse Selection Option Module can be installed NOT BOTH

Digital Dual Schedule Pulse MMI Panel

The Digital Dual Schedule Pulse MMI panel adds Pulse MIG welding capability and is the most advanced MMI panel for the

DuraDrive feeder line. Two welding parameters can be preset on the panel in either the standard (CV) or pulse MIG process

mode. The arc starting schedule is selected with the SCHEDULE select switch (A or B). The "Click Click" gun trigger schedule

switching technique can be used to change welding parameters while welding. This MMI panel MUST be used with a PULSE

SELECTION module installed on the wire feeder control cabinet rear panel. This module can be used with the ESAB 350MPi,

MTS-3500i, SVI-450i and MultiPower 460 (non-pulse version) power sources for MIG pulse welding. The DuraDrive feeder

is factory shipped congured for the ESAB 350MPi, MTS-3500i and MultiPower 460 power sources. MMI installation and

setup instructions for the SVI-450i power source conguration are included in the Dual Pulse MMI installation instructions

F15-703. Other ESAB power sources and competitors power sources will not operate in the pulse mode using this Pulse

MMI panel.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Brak uwag

ESAB MultiPower 460 Pulse Instrukcja Obsługi Strona 19