ESAB POWERCUT-1250 Instrukcja Obsługi Pobierz pdf (Strona 13)

4.1 STEEL HEAT SHIELD GUARDS

(Refer to Figure 4-1)

ADJUST GUIDE BY TURNING IN A

CLOCKWISE DIRECTION ONLY. THIS

WILL PREVENT ACCIDENTAL LOOS-

ENING OF SHIELD.

STEEL GUARD

STAND OFF GUIDE

P/N 0558002393

IF GUIDE IS TOO

TIGHT ON SHIELD,

OPEN SLOT WITH

SCREWDRIVER.

IF TOO LOOSE, CLOSE

SLOT WITH VISE OR

LARGE PLIERS.

3/16" (4.7 mm)

TORCH-TO-WORK

GUIDE AGAINST

STRAIGHT EDGE

OR FREE-HAND

CUT

Figure 4-1. Installation and Operation of Steel Heat Shield Guards

Drag cutting, even with lower current levels may signifi-

cantly reduce the life of torch consumables. Attempting

to Drag Cut with higher currents (above 40 amps) may

cause immediate catastrophic consumable damage.

Drag Cutting with the PT-32EH Torch

If drag cutting is desired, attach ESAB's standoff guide

(P/N 0558002393). For thin material, under 3/8" (9mm),

remove 50-70 amp or 90 amp nozzle from torch head,

insert ESAB's 40 amp nozzle (P/N 0558002908). Lower

current level to 40 amps or lower.

SECTION 4 OPERATION

NOTICE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

ESAB POWERCUT-1250 Instrukcja Obsługi Strona 13